Removing the ink cartridges will result in poor print quality and may cause damage to your printer.
Do not pull the ink cartridges out once you have started printing. Second, install the ink cartridges in the color slots that correspond to the color of the ink in the cartridge. First of all, make sure your ink is stored away from direct sunlight. These precautions will help ensure maximum ink life and that you get the best results from your ink. There are a few precautions you should take when using your NaturaLink. The small amount of original ink left in the lines and dampers will not have any noticeable effect on printability. Plug and print compatibility makes switching from one ink to another very simple. With NaturaLink B, you can print on 100% cotton or 50/50 blend shirts, just as you would with the OEM ink, except that the Sawgrass ink offers better washfastness at a lower cost.īest of all, the NaturaLink B cartridges are color matched with the OEM cartridges, so you can switch your cartridges out as you need to do so. Manufactured by Sawgrass Ink, NaturaLink B is a water based, environmentally friendly ink that has the same basic formula as the original Brother ink. (16) Connect the end of the Pump Tube to a Branch Fitting of the Drain Plug.īuy parts for your Brother GT-541 and GT-782.If you use an Brother GT-541 direct to garment printer, you will want to know about NaturaLink B Inks. (15) Pull out the Pump Tube from the top left of the Tube Pump while rotating the Rotate Gear in the direction of CW by hand. (14) Connect the Pump Tube on the top right of the Tube Pump with the L-shaped Tube Fitting on the Solenoid Unit, and then bind the elementary part with the KI Tie. (13) Fasten the two screws to fix the Tube Pump Rotor. (12) Slide the Tube Pump Rotor back into the Tube Pump Housing, and push down the Tube Pump Rotor until it clicks. (11) Apply the grease MOLYKOTE EM30-L (S58541000) lightly on the new Pump Tube. (Be careful of the direction to route the Pump Tube. (10) Fit the new Pump Tube in the U-shaped guide groove. (9) Turn over the Tube Pump Rotor and remove the Pump Tube. (8) Slide the Tube Pump Rotor upward to remove it.
(7) Remove the two screws (M3 x 35)that fix the Tube Pump Rotor. (6) Disconnect the Pump Tube from the L-shaped Fitting. (5) Cut the KI Tie with a nipper and then remove it. (4) Pull out the L-shaped Tube Fitting unit on the top right of the Tube Pump. (3) Disconnect the Pump TUbe on the top left of the Tube Pump connected with the Drain Plug. Replacing the Tube Pump Tubes of the Maintenance Unit
0 kommentar(er)
